The Glock's frame, magazine body, and several other components are made from a high-strength nylon-based polymer invented by Gaston Glock, called Polymer 2.  This plastic was specially formulated to provide increased durability and is more resilient than carbon steel and most steel alloys. Polymer 2 is resistant to shock, caustic liquids, and temperature extremes where traditional steel/alloy frames would warp and become brittle.  The injection-molded frame contains four hardened steel guide rails for the slide: two at the rear of the frame, and the remaining pair above and in front of the trigger guard. The trigger guard itself is squared off at the front and checkered. The grip has an angle of 109° and a nonslip, stippled surface on the sides and both the front and rear straps.  The frame houses the locking block, which is an investment casting that engages a 45° camming surface on the barrel's lower camming lug. It is retained in the frame by a steel axis pin that holds the trigger and slide catch. The trigger housing is held to the frame by means of a polymer pin. A spring-loaded sheet-metal pressing serves as the slide catch, which is secured from unintentional manipulation by a raised guard molded into the frame.
We have many A-Z keywords for this term. We offer them for FREE unlike many other keyword services, however we do require that you are a registered member to view them all so that the costs will remain lower for Us.
These are the linked keywords we found.